Single-Sided Belts: Have teeth on one side only, used for standard, unidirectional power transmission. Double-Sided Belts (DA/DB type): Have teeth on both sides. They can transmit power on two faces simultaneously, ideal for serpentine drives, multi-shaft drives, or reverse drives in compact spaces. DA type has teeth aligne...

Length: Defined by the Pitch Length (PL), e.g., 5M-1000 means 5mm pitch, 1000mm pitch length (200 teeth). Calculate the required length from your preliminary center distance and pulley teeth, then select the nearest standard length. Width: Determines the belt's load capacity. Calculate the effective tension and compare it t...

Design Power: Motor power multiplied by a service factor. Speeds: RPM of both the driver and driven pulleys. Drive Ratio: Determines the number of pulley teeth. Center Distance & Space Limits: Affects belt length and pulley size. Environmental Conditions: Temperature, humidity, exposure to oil, chemicals, or need for food-g...

Low power, high speed, compact space: Choose small pitches like 3M or 5M. Common in office equipment, small instruments, and servo motors. Medium power and speed: Choose 8M. This is one of the most common pitches in industrial automation, balancing capacity and size. High power/torque, lower speed: Choose 14M, 20M, or large...

Low power, high speed, compact space: Choose small pitches like 3M or 5M. Common in office equipment, small instruments, and servo motors. Medium power and speed: Choose 8M. This is one of the most common pitches in industrial automation, balancing capacity and size. High power/torque, lower speed: Choose 14M, 20M, or large...

Rubber Timing Belts: Have teeth on the inner circumference that mesh with pulley grooves to provide positive, non-slip drive with precise speed ratios. The backside may be flat or textured. Rubber Flat Belts: Have a smooth or coated surface and rely on friction for power transmission. They allow for some slip, are suitable ...

By Profile: Standard trapezoidal (e.g., MXL, XL, L, H, XH, XXH), curvilinear (e.g., 3M, 5M, 8M, 14M, 20M), and special profiles (e.g., AT, ATD). By Construction: Single-sided belts, double-sided belts (DA/DB type), molded endless belts, and open-ended belts. By Material: Rubber timing belts (Neoprene with fiberglass cords),...